RAMSET D60 Instruções de Operação Página 1

RAMSET D60 TOOLOPERATOR’S SAFETY & OPERATING INSTRUCTION MANUALDANGERTHIS TOOL FOR USE BY LICENSED OPERATORS ONLY.READ AND OBEY ALL SAFETY AND OPE

4. With the tool barrel closed to the semi-closed position and finger away from the trigger, open the cover by pressing the side button, and insert a

D60 POWER LEVEL ADJUSTMENTThe power level of the D60 tool may be adjusted for varying materials by changing the length of the barrel. Extending the b

Always make sure the tool is not loaded before performing any service or repair and always wear safety goggles when cleaning or servicing the tool.NOR

REFER TO PARTS SCHEMATIC FOR PROPER ASSEMBLY OF PARTS– Overdriving of fasteners – Excessive power – Change to the next lower power level

PARTS SCHEMATICPARTS SCHEMATIC 14

RAMSET D60 TOOL PARTS LIST KEY PART NO. DESCRIPTION 1 5466405 SPALL GUARD 2 13500 OUTER BARREL SHROUD (FRONT BARREL) 3 135010 OUTER BARRE

DISASSEMBLY 16DISASSEMBLYTOOL DISASSEMBLY1. Slide the barrel assembly out of the tool until the barrel shroud clip is exposed.2. Unscrew and remove

DISASSEMBLY 17DISASSEMBLY 5. Slide the barrel assembly from the outer barrel shroud and muzzle bushing.6. Unscrew the firing chambe

D60 WARRANTY AND LIMITATIONSPOWDER ACTUATED TOOLMANUFACTURES' INSTITUTE INC.TMConcrete Fastening SystemsGlendale Heights, IL 60139 800-RAMSET6 (1

Just as no one can merely read a book about driving an automobile and then hope to drive one safely, no one should attempt to use any Ramset tool wi

PreparationAcceptable Base MaterialsPowder actuated fastening is suitable for use in the following base materials only:• Poured Concrete• Structural

Loads & Load Selection Safety1. Always make a test fastening after being sure that the base material is suitable for powder actuated fastening

Tool Handling Safety1. Always be sure tool is operating properly before attempting to use it. Follow the “Daily Function Check” shown to the right

FAILURE TO FOLLOW INSTRUCTIONS CAN CAUSE INJURY TO THE TOOL OPERATOR OR TO BYSTANDERS.Fastener Driving Safety1. Only use the tool for fastening into

Your Ramset D60 Tool uses only the Ramset fasteners and loads shown below or listed for the tool in the Product Catalog.FASTENERS FASTENERS / L

FASTENING APPLICATIONSYour Ramset tool can be used for a wide range of fastening needs in a variety of base materials. Reading and following these i

TOOL OPERATIONDaily Function Test Always check the tool first to make sure that it does not contain a disc load or fastener. Test the tool several tim