RAMSET SA270 Instruções de Operação

SA270 TOOLOPERATOR’S SAFETY & OPERATING INSTRUCTION MANUALDANGERTHIS TOOL FOR USE BY LICENSED OPERATORS ONLY.READ AND OBEY ALL SAFETY AND OPERATIN

4. Hold the tool perpendicular (90°) to the work surface with both hands and press firmly to fully depress the tool. Maintain firm downward pressur

TROUBLESHOOTING TROUBLESHOOTING 11REFER TO PARTS SCHEMATIC FOR PROPER ASSEMBLY OF PARTS– Overdriving of fasteners – Excessive power

PARTS SCHEMATICPARTS SCHEMATIC 12SA270 G SeriesNOTE: The receiver weldment is not available as a spare part.

PARTS LIST / MAINTENANCE PARTS LIST / MAINTENANCE 13Always make sure the tool is not loaded before performing any service or re

DISASSEMBLY 14DISASSEMBLYTOOL DISASSEMBLY1. Depress the detent pin to release the pawl. 2. Lift the pawl up to release the barrel assembly. Check t

DISASSEMBLY 15DISASSEMBLY 6. Slide the front barrel from the rear barrel and remove the piston from the rear barrel. The tool is n

SA270 WARRANTY AND LIMITATIONSPOWDER ACTUATED TOOLMANUFACTURES' INSTITUTE INC.TMConcrete Fastening SystemsGlendale Heights, IL 60139 800-RAMSET6

Just as no one can merely read a book about driving an automobile and then hope to drive one safely, no one should attempt to use any Ramset tool wi

PreparationAcceptable Base MaterialsPowder actuated fastening is suitable for use in the following base materials only:• Poured Concrete• Structural

Loads & Load Selection Safety1. Always make a test fastening after being sure that the base material is suitable for powder actuated fastening

Tool Handling Safety1. Always be sure tool is operating properly before attempting to use it. Follow the “Daily Function Check” shown to the right a

FAILURE TO FOLLOW INSTRUCTIONS CAN CAUSE INJURY TO THE TOOL OPERATOR OR TO BYSTANDERS.Fastener Driving Safety1. Only use the tool for fastening into

FASTENERS / LOADS FASTENERS / LOADS 7Your Ramset SA270 Tool uses only the Ramset fasteners and loads shown below or listed for the to

FASTENING APPLICATIONSYour Ramset tool can be used for a wide range of fastening needs in a variety of base materials. Reading and follow these impor

TOOL OPERATIONDaily Function Test Always check the tool first to make sure that it does not contain a strip load or fastener. Test the tool several ti