RAMSET D45A Instruções de Operação

RAMSET D45A TOOLOPERATOR’S SAFETY & OPERATING INSTRUCTION MANUALDANGERTHIS TOOL FOR USE BY LICENSED OPERATORS ONLY.READ AND OBEY ALL SAFETY AND OP

4. Close the cover and be sure it is locked. NEVER attempt to make a fastening with the tool cover in the open or unlocked position.5. Hold the too

REFER TO PARTS SCHEMATIC FOR PROPER ASSEMBLY OF PARTS– Overdriving of fasteners – Excessive power – Change to the next lower power level

D45A PARTS SCHEMATICD45A PARTS SCHEMATIC 12

RAMSET D45A TOOL PARTS LIST KEY PART NO. DESCRIPTION 1 323300 MUZZLE BUSHING ASSEMBLY 2 316520 BUFFER (PKG OF 3) 3 30645 PISTON 4 323020M

DISASSEMBLY 14DISASSEMBLYTOOL DISASSEMBLY1. Uscrew the barrel retention collar and slide it away from the tool housing. Handle the tool carefully af

DISASSEMBLY 15DISASSEMBLY 6. Slide the barrel assembly away from the muzzle bushing.7. Remove the piston from the muzzle bushing.8.

D45A WARRANTY AND LIMITATIONSPOWDER ACTUATED TOOLMANUFACTURES' INSTITUTE INC.TMConcrete Fastening SystemsGlendale Heights, IL 60139 800-RAMSET6 (

Just as no one can merely read a book about driving an automobile and then hope to drive one safely, no one should attempt to use any Ramset tool wi

PreparationAcceptable Base MaterialsPowder actuated fastening is suitable for use in the following base materials only:• Poured Concrete• Structural

Loads & Load Selection Safety1. Always make a test fastening after being sure that the base material is suitable for powder actuated fastening

Tool Handling Safety1. Always be sure tool is operating properly before attempting to use it. Follow the “Daily Function Test” shown to the right a

FAILURE TO FOLLOW INSTRUCTIONS CAN CAUSE INJURY TO THE TOOL OPERATOR OR TO BYSTANDERS.Fastener Driving Safety1. Only use the tool for fastening into

Your Ramset D45A Tool uses only the Ramset fasteners and loads shown below or listed for the tool in the Product Catalog.FASTENERS FASTENERS /

FASTENING APPLICATIONSYour Ramset tool can be used for a wide range of fastening needs in a variety of base materials. Reading and following these i

TOOL OPERATIONDAILY FUNCTION TEST Always check the tool first to make sure that it does not contain a disc load or fastener. Test the tool several tim