RAMSET D45 Manual do Utilizador descarregar pdf (Página 9)

4. Insert type into the Portamark, filling the type pocket completely, with spacers if

necessary. Insert the type retention rod.

5. Insure that there are no powder loads in he Ramset. Depress the marking end of

the Portamark squarely against a typical marking surface and note if the safety

pawls spread to allow the tool to be completely depressed. If the safety pawls

spread, the assembly was completed successfully.

-Note- Reference drawing D-6651-K for a cross

section of this assembly.

The Assembled Tool

Pawls are not spread, preventing the tool

from firing. The type is not squarely

aligned on the part.

Pawls are spread. This allows the tool to

be completely depressed, and firing can

occur.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Sem comentários

RAMSET D45 Manual do Utilizador Página 9