RAMSET D45 Manual do Utilizador descarregar pdf (Página 15)

4.0 Troubleshooting and Parts List

4.1 Troubleshooting

Refer to parts schematic for proper assembly of parts

• Tool fails to fire • Failure to depress tool completely • See “Tool does not completely

depress” below

• Excessive dirt buildup on breech face

not allowing proper penetration of

firing pin.

• After following misfire procedure,

check firing pin indentation on load.

Clean breech face.

• Firing pin and/or breech damaged • Replace damaged parts

• Failure to open safety pawls. • Safety pawls and/or anvil damaged

or broken

• Tool does not

completely depress

• Disassembled or damaged parts • Check all parts in the receiver for

damaged or improper assembly

• Reduction or loss of

power

• Piston not being returned to full rear

position

• Barrel must be pulled completely

open to properly position the piston.

• Worn or damaged piston • Replace damaged or worn parts

• Worn or broken pawls • Replace pawls

• Powder load disk is bent (Can result

in tool firing, but marking does not

occur)

• Replace powder load disk

When cocking tool, extend barrel firmly,

but not with excessive force

• Tool cannot be cocked

or opened

• Excessive dirt buildup • Clean tool thoroughly

• Damaged or bent piston • Replace piston

• Broken or damaged parts • Do not use tool. Contact ITW

Ramset for service

• Failure to index disc • Disc not inserted correctly or

damaged

• Check load disk-Properly discard

damaged disks

• Damaged indexing mechanism • Contact ITW Ramset for service

1 2 ... 10 11 12 13 14 15 16 17

Comentários a estes Manuais

Sem comentários

RAMSET D45 Manual do Utilizador Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas elétricas RAMSET D45