RAMSET T3SS Instruções de Operação Página 3
- Página / 22
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Preparation For Fastening
Acceptable Base Materials
The gas powered T3 tools are
suitable for use in the following
base materials only:
• Poured Concrete
• Structural Steel
• Concrete Block and Horizontal
Joints in Brick or Masonry Walls
Never attempt to fasten into any other
type of material.
Fastening into other
materials can cause blindness or other
serious injury.
Never attempt to fasten into very hard
or brittle materials such as cast iron,
tile, glass, or rock of any type.
These
materials can shatter, causing the fastener
and/or base material fragments to fly free
and cause serious injury to the tool operator
and others.
Never fasten into any base material that
does not pass the Center Punch test.
Failure to assure the suitability of the base
material can result in serious injury to the
eyes or other body parts.
Center Punch Test
ALWAYS WEAR SAFETY GOGGLES
WHEN PERFORMING THIS TEST.
1. Always check the material being
fastened into for hardness before
attempting any fastening operation.
2. Using a fastener as a center punch,
strike the fastener against the work
surface using an average hammer
blow and check the results.
Center Punch Test Results
1. If the fastener point is flattened,
the material is too hard for a
powder actuated fastening.
2. If the fastener penetrates the material
easily, the material is too soft.
3. If the material cracks or shatters,
the material is too brittle.
4. If the fastener makes a small
indentation into the material, the
material is suitable for fastening.
Structural Steel
Solid or Hollow
Block
Horizontal Joints
only in Brick Walls
Solid Concrete and
Precast Concrete
SAFETY INSTRUCTIONS
DANGER
3
DANGER
SAFETY INSTRUCTIONS
- RAMSET T3 TOOL SYSTEMS 1
- Acceptable Base Materials 3
- Center Punch Test Results 3
- FASTENING APPLICATIONS 4
- Holds both 6
- FUEL CELL 8
- TOOL OPERATION 10
- Operating the T3SS Tool 10
- Removal of Rear Foot Assembly 10
- QUICK CHANGE NOSE 11
- QUICK CHANGE NOSE 11
- Operating the T3 Tool 12
- PARTS SCHEMATIC 13
- PARTS LIST 14
- T3 MAGAZINE NOSE ASSEMBLY 17
- SERVICING / TROUBLESHOOTING 19
- WARRANTY 21
- © ILLINOIS TOOL WORKS 2008 22
Manuais e produtos relacionados com Ferramentas elétricas RAMSET T3SS
(16 páginas)
(20 páginas)Juno JGI4424 podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Zamrażarki Juno JGI4424.
Dostarczamy 1 pdf podręczników Juno JGI4424 do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Comentários a estes Manuais